Lab Gruppen PD3000 3000W Power Amp at

Description

Full View Full FeaturesHuge power output from two channels with 1500W eachLightweight and powerful Class-D amplification technologyHighly efficient with a Switch Mode Power Supply (SMPS)Protects your drivers from peaks and clipping with a Speaker Protect LimiterMonitor every aspect of your amps performance with accurate 8-segent Signal and Limiter LEDsEasy frequency management from an integrated crossover with low-cut, high-cut, and full range modeFully protected against short circuits, DC, and thermal overloadPristine signal from balanced XLR and TRS input connectorsPrevents overheating with a temperature-controlled fanRugged chassis for maximum durabilityCan be installed in any standard 19” rack unitSpecificationsGeneralNumber of amplifier channels: 2Peak total output of all channels driven: 3000WPeak output voltage per channel: 115VPeak output current per channel: 32ABridge mode: NoOutput circuit type: Class-DAmplifier outputsMax output power (all channels driven)2 ohms per channel, stereo: 1000W4 ohms per channel, stereo: 1500W8 ohms per channel, stereo: 800WAudio performanceTHD+N 20 Hz – 20 kHz @ 1 W: (less than) 0.1 THD+N @ 1kHz, 1 dB below clip: (less than) 0.1 Signal-to-noise: (more than) 90 dBChannel separation (Crosstalk) @ 1 kHz: (more than) 75 dBFrequency response: 10 Hz to 20 kHz, +0.5/ -1 dBInput impedance: 10 kΩ unbalanced, 20 kΩ balancedDistortion,1/8 rated power: (less than) 0.1 SystemControlFront: Power switch, Gain controls (channels A and B)Rear: Stereo / mono, switchable Xover: LF / full range / HF, switchableCrossover frequency: 100HzIndicatorsPower: RDY LEDs lit greenLimit, per channel: LIM LEDs lit redSignal, per channel: -30 dB, -24 dB, -18 dB, -12 dB, -9 dB, -6 dB, -3 dB, LEDs lit green/orangeThermal Warning, per channel: RDY LED blink orangeThermal Warning 90 , PSU: Both RDY LEDs blink orangeThermal fault, per channel: RDY LED blink redThermal fault 100 , PSU: Both RDY LEDs blink redFault, channel: RDY LED lit constantly redFault, device: Both RDY LEDs constantly lit redConnectorsInputs / link: 2 x XLR, 2 x 1/4″ TRSOutputs: Neutrik speakON (2 x NLT4)Mains connector: Locking IEC appliance inlet, C14Protection featuresCooling: Two fans front-to-rear air flow, temperature controller speedAmplifier protection: Thermal and DC protection, Rail sensing and peak current limitingLoad protection: Controlled start and shutdown, behavior, DC-fault protection, Short-circuit protectionPower supplyVoltage: Separate 230 V and 115 V versions available. Not selectable on the productPower consumption @ 4 ohms: 1050 WUK / AUS / EU / Korea / China: 220-240 V, 50/60 HzOtherDimensions: 93 x 483 x 326mm (H x W x D)Weight: 6.5kgProduct code: STA-125Lab Gruppen PD3000 3000W Power Amp at